I've been asked if it's possible to make a fixtyre for the press, so we can place a Ø38mm 45* bend and press it at the end.
Can my TNC-155 do this task, ( I don't have CAM:drowning: )
I've been asked if it's possible to make a fixtyre for the press, so we can place a Ø38mm 45* bend and press it at the end.
Can my TNC-155 do this task, ( I don't have CAM:drowning: )
CEAndersen.dk :specialty production in stainless steel
The 155 is a full 3 axis control, so the real question is can YOU do the job?
Obviously I cannot envision your job, but without CAM it is impractical to do 3 axis contouring, but if you are only making a bending die, I can't see it as that difficult to program
I guess it'll be an outside job.
Then I don't have to take the blame if ther's a f... up![]()
And I don't think that I can presuade my boss to give me CAM in birthday pressent
CEAndersen.dk :specialty production in stainless steel