Originally Posted by
Ken_Shea
TM-1 mill
It's been giving me issues for some time but with repeated (10-15) re-set and Startup/restarts with usually (No Z Zero) it would finally boot up and function normally for the remainder of on time.
Today was a first, went through dozens of startup procedures with it finally booting up an functioning normally although this was short lived and soon alarmed out after a few tool set up changes or axis movements.
These are the multiple errors produced by these numerous re-starts, they came in no particular order or sequence.
Z Zero Ret Mar too small
Y Limit switch
X Limit switch
Z Limit switch
No Zero Y
No Zero X
No Zero Z
Seems quite unlikely all three switches went bad and/or causing trouble suddenly.
I'm open for any ideas or suggestions.