588,246 active members*
4,403 visitors online*
Register for free
Login

Thread: Fanuc 10m DNC

Results 1 to 3 of 3
  1. 10-21-2004, 12:42 AM #1
    mroy0404
    mroy0404 is offline Registered
    Join Date
    Aug 2004
    Posts
    218

    Fanuc 10m DNC

    I have a fanuc 10m that I can not DNC,talked too a few people about it and they say that the PLC latter has to be changed and a new switch installed on the controller for it to run in auto.
    There is no position on the switch for the tape mode.

    Any help

    Mike
    Reply With Quote Reply With Quote
  2. 01-14-2005, 06:59 PM #2
    psevin
    psevin is offline Registered
    Join Date
    May 2003
    Posts
    75
    If you want to do true DNC (execute part program as it is being transferred via RS-232) then that is the ONLY solution. Can't imagine anyone doing it for less than a couple grand.

    Sorry for the bad news.

    Regards,

    Paul Sevin
    Ovation Engineering, Inc.
    http://www.ovationengineering.com
    Paul Sevin - Ovation Engineering, Inc.
    http://www.ovationengineering.com
    Reply With Quote Reply With Quote
  3. 01-14-2005, 09:56 PM #3
    Spezzaferro
    Spezzaferro is offline Registered
    Join Date
    Dec 2004
    Posts
    27

    running tape mode/drip feed

    I experienced this about 10 years ago on a 10m.
    I'm not quite sure if anything had to be changed initaially in the ladder
    but i do know that we had to change a pc parammeter in the "keeprl"
    that wouldchange our"memory switch" to tape. it worked with no problem.
    Any service guy familiar with fanuc controls should be able to do it for nest to nothing
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. DNC Feeding your Fanuc Controller
    By Gerry Newe in forum Fanuc
    Replies: 8
    Last Post: 10-02-2012, 12:09 AM
  2. mazak v5 micrcenter w/ fanuc 6m b dnc??
    By wild01 in forum DNC Problems and Solutions
    Replies: 4
    Last Post: 12-24-2010, 02:06 AM
  3. Fanuc 3M DNC operation
    By max_c in forum Uncategorised MetalWorking Machines
    Replies: 3
    Last Post: 07-05-2010, 01:11 AM
  4. Fanuc 10m
    By mroy0404 in forum DNC Problems and Solutions
    Replies: 9
    Last Post: 05-08-2008, 12:48 AM
  5. Fanuc 10M help needed...
    By rrcnc in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 10-21-2004, 12:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules