Had a pretty big crash the other day.
I think it was bigger than they let on, because the chuck jaw was laying in the bottom of the machine......OUCH

after we replaced the inner and outer pins. we are having issues with turret not indexing properly.

we set at tool 1 and did the home sequence as explained in the vision manual starting page 20.
but when we index. it does not index the proper amount.
and when we go from tool 1 to say tool 5 and then back to tool 1. it does not go back to the proper place for tool 1.

I think I got things wrong in the parameters somewhere. but cant figure it out.

it is a 12 pos turret.
vision drive is dvcs -tm series

Thanks in advance

Mike