[stovepipesteve]

If i remove the table probe due to large work piece,what im i looking at to get it back in and calibrated?
i am familiar with spindle and table calibration.
How do i let the mach. know where the new table probe position is to start my calibration?
Is it even wise to remove it?
thanks in advance.

[pit202]

have you read the ts27r probe manual ? you can remove it, but then you need to recalibrate it , this is a smilar method to spindle probe calibration, you can also make 2 holes in table and pin it together like here : http://www.renishaw.com/media/pdf/en...e35f498c54.pdf

[timan]

Just follow your Visual Quick Code calibration process shouldn't take more than 10 minutes! Pretty simple! Main thing is to make sure the touch disc is flat.