I have seen a nice comparison table for mini mills at Mini Mill Comparison - LittleMachineShop.com but haven't found anything similar for slightly larger mills. Anyone know of one for BF20/G0704/etc.
Results 1 to 2 of 2
-
02-01-2017, 08:06 PM #1
Junior Member
- Join Date
- Aug 2012
- Posts
- 279
Anyone have a comparison table for different models of BF20 size mills?
-
02-04-2017, 07:16 PM #2
Member
- Join Date
- May 2008
- Posts
- 1185
Re: Anyone have a comparison table for different models of BF20 size mills?
The BF-20 and G0704 are vary close to the same size but with different layouts. The tables have the same working area but the PM-25 has different end plates.
Each major competent like the column, base and table weigh about the same. The heads are the same with different motors.
Both are good mills.youtube videos of the G0704 under the name arizonavideo99
Reply With QuoteSimilar Threads
-
Adjusting BF20 to be square to table
By outsider787 in forum Benchtop MachinesReplies: 11Last Post: 07-31-2011, 03:14 PM -
BF20 Machining underside of X table
By bladehunter in forum Benchtop MachinesReplies: 4Last Post: 11-30-2009, 11:26 AM -
Table Size for a TM3?
By schoobie in forum TorchmateReplies: 1Last Post: 03-22-2008, 06:40 PM -
table size
By Jimmyh in forum Mach Software (ArtSoft software)Replies: 5Last Post: 08-30-2007, 04:33 PM -
XY table design basics, linear ways to table size ratio?
By Konstantin in forum Mechanical Calculations/Engineering DesignReplies: 0Last Post: 03-13-2007, 06:21 PM
Tags for this Thread
Posting Permissions
