I know this isn't a PIC but I thought someone might have seen this before.
I'am using the Parallax Basic Stamp 2 with it's free Basic Stamp editor 2.3.1
I get a error message when I launch the editor.
If I click Try Again it will not launch if I click Cancel or Continue twice it will launch.
Once it's open it seems to work fine and I've tried some of the sampe code which all seem to work fine except for one that flashes a LED, It's very week.
The board is serial with a new 9volt for power.It might just be the LED I'am using requires too much power I'am not sure.

Exception Processing Message c0000013 Parameters
75b6bf9c 4 75b6bf9c 75b6bf9c