[roncnc]

Hi everyone,

I am using mastercam x4. when it comes to chaining the entities for toolpath:
1 the chaining arrow does not show
2 the chained entities does not highlighted either
but I can still generate toolpath
any setting so I change that
help please
thanks
Ron

[AiR_GuNNeR]

The first thing I would check is in your setting, make sure that the colors are set correctly, i.e. perhaps the arrows are set tot eh same color as the background?

[Superman]

I'm leaning towards a graphics support setting...mine are OpenGL-ON, Disable hardware accel -ON, Disable front buffer-OFF
or the Chaining settings
attached pictures of my settings

but, if it doesn't solve it
Put your mcamx.config (inch)or mcamxm.config (metric)file into a compressed folder (.ZIP) and attach it to your next message

I'll try to compare it to mine

PS. There is a Mastercam forum here on the Zone, go into that forum & do a search.....you may be surprised what other goodies & tips that you could find