I have workpieces that are processed in successive cuts along a continuous piece of flat bar and then a chop saw separates them; each individual workpiece length now varies slightly.
The next operation, multiple workpieces are mounted to a fixture plate by alignment dowels and screws.
Since the WP edge does not reference it's prior operation, the fixture plate must provide the G54 reference point.
Is there an optimum way to create a G54 reference point on a fixture plate?
The fixture plate would need to be imported into the CAM with the parts (or rather the other way around) and the parts must be referenced to the fixture plate G54.
I use SprutCam and this sounds like an opportunity for a mudslide.
Is there a better way?