Probing is done with a G31 move. The probe will move towards the commanded position. If the probe is tripped during the move, Mach3 will decelerate to a stop, and the move is finished.
Not the same as homing at all.
Probing is done with a G31 move. The probe will move towards the commanded position. If the probe is tripped during the move, Mach3 will decelerate to a stop, and the move is finished.
Not the same as homing at all.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)