[mactec54]

Ok, placed order for the clamping style from Digikey.

https://www.digikey.com/product-deta...8102-ND/303956


and updated wiring diagram to make connection from FILTER GND to VFD GND

the clamp is will be attached to grounding plane (Case)
Attachment 431556

You don't need the extra Ground wire from the Star Point to the VFD Drive

[kinghong1970]

You don't need the extra Ground wire from the Star Point to the VFD Drive

thanks...

[kinghong1970]

I know, it's like watching paint dry... but small baby steps here... thanks for your patience.

decided to cut a sheet of aluminum to use for internal panel for the box. the box came with studs welded on it and the panel that they sell are very small.
this is a tighter fit but can easily insert panel and mount to box.
Attachment 431678

after test fitting, marking out the mounting holes, drill & tap 8-32...
Attachment 431680

dry fitting all components onto panel
Attachment 431682

panel fits nicely inside... a bit snug and i recall HY manual stating to give 50mm space around the sides of VFD...
wondering if this is too tight. i will have a 120mm fan actively pushing air from bottom of case.
Attachment 431684

decided to put the power cord and switch to side of case... front of case was getting too crowded.
Attachment 431686

some more wiring to be done...
thanks.

Al