Quote Originally Posted by Pplug View Post
The best thing you can do to that machine is to convert it to run Mach 3 with g540 motor controller. I ran a stock techno for years with the standard g code interface. It was horrible. I then stepped up to running it with the standard electronics and a controller called Gallad with the Kay interface. Finally I bit the bullet and converted it to run mach3. I now get full use of the machine with incredible speed, power and features like spindle speed control and a Z touch off plate.

In retrospect, I should have done it years ago!
How did your modification go connecting the g540 controller? How did you connect it and did you change out the power supply? Thank you.

Rick McCaskill
[email protected]