Hi all,
Today should be Monday cause nothing is going right...
Our 10M based milling machine developed an OT0001 error first thing today during the homing sequence. EMG and HND RESET are also displayed on the screen. Nothing we tried would allow us to move the X-axis away from the soft limit...
After searching the internet and reading the manual we followed a procedure to enter IPL mode and turn off the check soft limit at startup feature. When we try to exit IPL mode we now get an error message, something about a "label error" and we are stuck there, can't get out...
We've since manually turned the ball screw to bring the x-axis back to around mid-travel but are stymied with the IPL mode error... Please help !!!!
Thanks,
Mike