simpson36

On position Range
So this is always put into a servo system, it does not STATE that they have this small following error, this is just part of a servo system

It's just what happens if there was a out of postion error, & what will take place after it reached 126 steps, But this is not likely to happen

When you have a 14 bit encoder (16384 counts per rev x 4= 65536 counts per rev
you would never be able to measure the amount on the cut part even if it was out
by 126 steps

Which it would never be

I have tested them at 600ipm & have not been able to measure any out of position

As I have said before they do not have this small fixed following error you keep talking about.