[Arbo]

I'm ready for it. Just hooked up my probe line again and tested the process with the blue screen. Seems to work like a champ. Now to run out and get some new MDF to replace my chewed up table base and embed a piece of copper in a spot.

[ger21]

I'm ready for it. Just hooked up my probe line again and tested the process with the blue screen. Seems to work like a champ. Now to run out and get some new MDF to replace my chewed up table base and embed a piece of copper in a spot.

My intent is to modify the M6 End macro, so tool changes are more "automatic" than with the modified Blue screen.

There's a button for the initial Auto Zero, but the second button won't be needed if you call an M6, as the code will be in the macro.

If you prefer to manually call the second macro with a button, I'll make an alternate version and replace the M6 button with the second button.

There shouldn't be any more changes from this. At least I hope not.