Hi Everybody,
I'm busy setting up mach3 for my rockcliff build but I'm struggling a bit. Here is some information:
- Using 305Oz motors from hobbycnc
- Controller is set to 1/2 step
- Using a 6mm (hardware store) thread with a 1mm pitch
I'm working in mm and I'm trying to have configure it so that 1 unit = 1 mm.
at the moment 1 unit = roughly 5mm
What can I check or where am I going wrong?
(1) Steps per unit is set to 2000
(2) Velocity is about 35
(4) Accel is about 4