So I'm new to Bobcad. I made a small program, profile 4 small pockets etc, no big deal. All looks good, verify the program part looks great.
Try to run it on my Milltronics machine ,watched it on the graph produce 2 pockets then it stops, error 509 arc lacks intersection, looks like a break in the run. Downloaded NC plot and tried to run, that gave me a lot of errors like:
start radius and end radius are different by more than .001"
What is going on?
Are there some default settings I'm missing, I went to the preferences and changed the system tolerance from .003 to .001, and the Chain selection from .025 to .001 but that didn't make any difference.
Regards, ray.