I honestly can't figure it out. The manual goes through the QCTP set up, but I'm trying to do offsets for the turret, and I'm not sure how to change the tool.
Thank you
Results 1 to 10 of 10
Threaded View
-
12-22-2015, 09:43 PM #1
Registered
- Join Date
- Sep 2015
- Posts
- 33
How do I actually change the tool with a turret?
Reply With QuoteSimilar Threads
-
How to change Tool change position(About MAZATROL T1 control)
By liushuixingyun in forum Mazak, Mitsubishi, MazatrolReplies: 6Last Post: 01-07-2014, 01:33 AM -
Automatic tool changer program for a 8 tool turret Diy lathe cnc
By tessen in forum Dynomotion/Kflop/KanalogReplies: 11Last Post: 01-04-2014, 05:05 AM -
Change position numbers in turret
By fomaz in forum FanucReplies: 2Last Post: 12-12-2012, 07:17 AM -
Macturn: Tool change during lower turret move
By Green Button in forum OkumaReplies: 2Last Post: 12-20-2010, 07:37 AM -
Tool Turret Fault Alarm on TL-1 with no Turret?
By Edster in forum Haas LathesReplies: 10Last Post: 02-08-2010, 03:35 PM
Tags for this Thread
Posting Permissions
