[DiaLFonZo]

I thought if you were using 12v you don't need the resistor?

Hi,

Would like to clear this.
I have try wiring like that this morning.
Result are that i have the input at all time (LED Red)
The LED on the switch does change from when it see the metal or not.

Could you clarify that plz.

Eric

[gio666]

If prox are hooked up without resistor, the light will come on when it is triggered . If hooked up with resistor it turns into a PNP with power in line till it is triggered.

[gio666]

ViperXZ , all 30mm rails and 5 inch travel Z axis. Closer to 6 inch travel now

http://www.xzerocnc.com/forum/showth...machine-set-up

[DiaLFonZo]

If prox are hooked up without resistor, the light will come on when it is triggered . If hooked up with resistor it turns into a PNP with power in line till it is triggered.

It trigger now on the led on card.
Nothing between plus and input.

But nothing happen in mach3

[gio666]

You have to set them up in mach3 , set as limit or home or both

[gio666]

ViperXZ 1 HP ER20 spindle will have lots of vids, them will do the same with 2.7HP spindle to show difference

[gio666]

[DiaLFonZo]

You have to set them up in mach3 , set as limit or home or both

Yes and nothing show in diagnostic page.

[gio666]

That is the new 5 inch 20mm Z axis

[gio666]

Ill have these ones set up tomorrow and will post all info on my forum

[jassaf]

Hi, George:

My ball screw shrank during shipping? ...18mm

.

[gio666]

The bottom bearing house should be on the top

[gio666]

You still get almost 5 inch travel that way too, just set soft limit there or reverse bearing houses

[gio666]

This is how yours goes together

[jassaf]

This is how yours goes together

ok, the ball nut at the top.

.

[DiaLFonZo]

George...
You built mine with the ballscrew on bottom on mine too

[jassaf]

George...
You built mine with the ballscrew on bottom on mine too

I would have preferred a longer ballscrew ..... Since the new version
.

[jassaf]

George, another question:
why the Z plate, your do not do a few mm longer? the alignment would be easier.

.

[jassaf]

and also a slightly wider.
It would also be good, not hinder the screw head to place the spindle mount.:idea:

The viperX is very easy to do the assembly, but, must modify the Z plate.
The vast majority of buyers do not have the ability to George, for alignment.
.

[DiaLFonZo]

I don't find that an issue myself.
The plate align almost by itself and my K2 mount bolt from the outside

Eric - DiaLFonZo

Sent from my cellphone using Tapatalk