Card MKX-IV. If the axis A configured slave from the Yaxes, when pressed “Ref all Home” Mach3 does not respond to the switch Ahome only switch the main axis. Don't work A axis home.
Mach3Mill.xml: https://yadi.sk/d/48R5yb4YtrH2n
Card MKX-IV. If the axis A configured slave from the Yaxes, when pressed “Ref all Home” Mach3 does not respond to the switch Ahome only switch the main axis. Don't work A axis home.
Mach3Mill.xml: https://yadi.sk/d/48R5yb4YtrH2n
Contact the card manufacturer and ask if there plugin supports slaved homing.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Make sure that "Home Slave with Master" in General Config is NOT checked.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Sounds like the plugin does not support slaved homing.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
You are right, the plugin works incorrectly. View time when triggered "A Pos" led'
https://youtu.be/BaBQIyiBmOM
Hello
I have the same card mkx-IV driver v2.39.9 and mach3.
Have you been able to solve your problem?
I have a switch on each motor of my axis (Y & A).
Axis A is slave to the Y axis.
When I run a RefHome RefHome (2),
1- Y and A move together until touching switch Y.
2- Y and A stop
3- Nothing happens but I have to trigger switch A by hand.
4- Y and A go back.
If I resume the step by first releasing the switch A
1- Y and A move together until touching switch A.
2- Y and A do not stop
3- I trigger the Y switch by hand.
4- Y and A stop
5- Y and A go back.
An idea of ??why this behavior?
MyShop