I've got my wiring completed and am trying to get my motors to run, but I've run into a stumbling block.

I've got my straight through parallel cable (verified), g540 with a green light, all 4 motors connected (2 on the X axis, A set to slave in settings), verified my motor wiring to the G540 and followed the Mach3 setup guide for our package PDF on the kelinginc site.

I have not been able to load the mach3mill.xml file from the Kelinginc site. When I try to open it in mach3, it tries to load all on one line and gives the error 'line too long' in a status box. If I try and move the motors with a command like g0 x10 y10 z10, I can see the DROs move on the screen but the motors dont move with it.

Also, my estop works mechanically, but I can't get it to be recognized by mach3. Not sure what to do about that.

Please advise me on what I should try next.

Thanks!