[NCEd]

Hi,

I have a fairly old CNC router with a Fanuc OM-B controller. When running sub programs using work offset G52, I get an 010 P/s Alarm, invalid G code. I am assuming this is caused by the controller not processing the G52 code.

My question is, is the G52 turned on by an option parameter (900's) or perhaps a diagnostic or is it simply not supported by this controller.

Thanks

Ed

[sld4121]

HI Ed -

I did not see it as an option parameter in my OM-C parameter lists.
I presume they are approximately the same, but no way for me to tell.
I would give Fanuc a jingle and see what they say.

[greenery_fr]

Hi,

I have a fairly old CNC router with a Fanuc OM-B controller. When running sub programs using work offset G52, I get an 010 P/s Alarm, invalid G code. I am assuming this is caused by the controller not processing the G52 code.

My question is, is the G52 turned on by an option parameter (900's) or perhaps a diagnostic or is it simply not supported by this controller.

Thanks

Ed

PM me your email