I understand that when wiring a limit switch using shielded wire the shield should be tied to ground at the controller/BOB end only. My question is that when you wire the switches in series, do you tie the shields together from one switch to the next until you reach the final switch?
Wolfspaw
Results 1 to 3 of 3
-
12-27-2011, 07:02 PM #1
Registered
- Join Date
- Jan 2005
- Posts
- 42
Series Limit Switches with Shielded Wire
-
12-27-2011, 07:06 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24223
Yes.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
12-27-2011, 09:54 PM #3
Registered
- Join Date
- Jan 2005
- Posts
- 42
Thanks, Al.
Wolfspaw
Reply With Quote
Similar Threads
-
How to wire my limit switches
By Eddieman in forum Open Source CNC Machine DesignsReplies: 15Last Post: 10-28-2011, 04:05 PM -
How did you wire your Mesa 7i37 Limit Switches??
By torinwalker in forum LinuxCNC (formerly EMC2)Replies: 2Last Post: 03-08-2011, 02:20 AM -
Bridgeport Series II Interact 2 EMC retrofit -- limit switches
By ichudov in forum Bridgeport / Hardinge MillsReplies: 2Last Post: 06-28-2010, 01:15 AM -
How to wire E-Stop Buttons and Limit Switches which Pin in Printer Port
By guy2b1 in forum CNC Machine Related ElectronicsReplies: 7Last Post: 06-09-2009, 01:36 PM -
How to wire three limit switches
By bgolash in forum CNC Machine Related ElectronicsReplies: 1Last Post: 02-16-2006, 07:38 PM
Posting Permissions
