603,383 active members*
3,324 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Uncategorised CAM Discussion > Help with motor tuning steps per in mach3

Thread: Help with motor tuning steps per in mach3

Results 1 to 2 of 2
  1. 05-27-2012, 08:56 PM #1
    fixitdaz
    fixitdaz is offline Registered
    Join Date
    Mar 2012
    Posts
    0

    Help with motor tuning steps per in mach3

    hi guys do any of you know how to tune a motor in mach 3 the motor is a 7.5 degree stepper motor with 8mm 1.25pitch threaded rod.

    i am thinking steps per motor rev times how many micro steps divided by the pitch so is it 48 x 1 / 1.25 = 38.4
    This seems low any help would be appreciated
    Thanks Darren.
    We don't have problems, We only have challenges.
    CNC Milling Machine Build ( time-laps)
    Reply With Quote Reply With Quote
  2. 05-27-2012, 10:25 PM #2
    fixitdaz
    fixitdaz is offline Registered
    Join Date
    Mar 2012
    Posts
    0

    motor spec

    i have this info on the motors we are using

    sorry guys for some reason this post has posted twice the post is at http://www.cnczone.com/forums/showth...97#post1119797
    Attached Files Attached Files
    We don't have problems, We only have challenges.
    CNC Milling Machine Build ( time-laps)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. motor tuning in mach3
    By topchippy1 in forum Mach Software (ArtSoft software)
    Replies: 4
    Last Post: 06-22-2012, 10:04 PM
  2. mach3 motor tuning
    By taigfraeser in forum Taig Mills / Lathes
    Replies: 9
    Last Post: 07-03-2010, 05:51 PM
  3. how to setup the steps per unit in config->motor tuning
    By lucky021 in forum Canadian Club House
    Replies: 3
    Last Post: 05-06-2010, 07:04 PM
  4. Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR)
    By MDF_Markazi in forum Mach Software (ArtSoft software)
    Replies: 7
    Last Post: 04-30-2009, 08:15 AM
  5. Motor tuning under Mach3
    By BAustin in forum Charter Oak Automation Support Forum
    Replies: 3
    Last Post: 12-24-2006, 06:23 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules