The motors you show are open to chips getting in. Have you built a covering for them and do they not overheat with a cover.
Results 1 to 20 of 141
Threaded View
-
05-21-2016, 02:31 PM #9
Registered
- Join Date
- Jul 2014
- Posts
- 51
Re: Open source low cost servomotor controller
Reply With QuoteSimilar Threads
-
Would you participate to an open-source CNC controller?
By eSilviu in forum PollsReplies: 31Last Post: 08-24-2015, 10:03 AM -
Smoothie CNC controller, Open Source.
By Rolf_K in forum Laser Engraving / Cutting Machine General TopicsReplies: 6Last Post: 01-15-2015, 07:41 PM -
CNC Controller with Arduino - open source
By Christian Knüll in forum Open Source Controller BoardsReplies: 16Last Post: 12-22-2012, 10:46 AM -
Open Source CNC Controller Specification
By gregmary in forum DIY CNC Router Table MachinesReplies: 28Last Post: 12-05-2005, 04:58 AM -
BEST Open source Controller ?
By Seventeen in forum Open Source Controller BoardsReplies: 12Last Post: 09-22-2005, 12:27 AM
Tags for this Thread
Posting Permissions
