603,912 active members*
3,021 visitors online*
Register for free
Login

Thread: Gecko panel wired

Results 1 to 3 of 3

Threaded View

jimglass Gecko panel wired 06-12-2003, 04:52 AM
balsaman Nice, should have lots of... 06-12-2003, 05:30 AM
janealva93 Re: Gecko panel wired 03-11-2025, 04:36 AM
  1. 06-12-2003, 04:52 AM #1
    jimglass is offline Registered
    Join Date
    Mar 2003
    Posts
    104

    Gecko panel wired

    Hi,

    Just a little show and tell. I'm almost ready to make chips and discovered I need a different printer cable. Need pins at both ends. The steppers lock when powered up so that is a good sign. No smoke either.

    I'm using the Axxus control board and three Gecko boards to drive 550 oz/in steppers. Probably make chips tomorrow night.

    I built this with knowledge obtained right here. Thanks for all the pointers. A Servo project will be next.

    Jim
    Attached Thumbnails Attached Thumbnails electric panel.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Gecko vs Rutex
    By samualt in forum Gecko Drives
    Replies: 20
    Last Post: 10-21-2004, 07:48 AM
  2. CNC Operator Panel Design
    By Al_The_Man in forum DIY CNC Router Table Machines
    Replies: 17
    Last Post: 09-13-2004, 06:03 PM
  3. Servos or Steppers..... and other gecko related questions
    By UKRobotics in forum Gecko Drives
    Replies: 11
    Last Post: 04-19-2004, 08:14 PM
  4. To Gecko, or not to Gecko...that is the question!
    By samualt in forum Gecko Drives
    Replies: 11
    Last Post: 09-23-2003, 02:42 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules