[bgolash]

Hi Group

I`m not clear on a few points when integrating the hardware and
software. I will be using Gecko drives for steppers. Does the
gecko drive come with configuration software to set the step and
direction. Or do I need some third party software to setup the
machine.
:drowning:

[InventIt]

need Mach1 or Mach2
OR
TurboCNC
Or
some other software like KCam etc.

This will send step/dir signals to the Geckos via parallel port.
Think of your drives (Geckos) as amplifiers. They see small voltage signals from Computer and send high voltage signals to motors.

[Hardwarekill]

Take the best !
PCNC31
2,5D or real 3D

HPGL and G-Code

WWW.Lewetz.de


Michael