Attachment 317898
I have this part I need to program. it is clamped in a vice and leveled along the tan line. There are 2 jacks supporting it below the red and purple dots.
I am going to the landing where the red dot is and hand facing it, just enough to get a flat surface. About 2/3 of the area will be cut, back to the black line.
I then set my tool height there without raising or lowering the tool. I then raise the tool up 8.060 and face the area with the green dot. This is a welded part so it has some warpage and the face cant be trusted to be uniform from part to part so I have to start high (about .150) and come down to the correct height.
XY home is at the yellow circle (for reference).

Question is.....How do I program this to raise 2 inches above the green dot area then move over to face in .040 increments down to 8.060 height? (Hopefully using the red dot area for tool touch off).

It also has 4 holes drilled in it but that is easily overcome after I learn how to face it off.

This is on a HAAS VF3 and MasterCAM x7.

Thanks in advance for the help,
Yoda